TRIMAX TECHNOLOGIES by TEAL

 VIPA and VIPA+ have been designed to give the operator total confidence when taking voltage and current readings. The linearly driven bed of nails creates a low-resistance electrical contact with the conductive wire cores through the wire insulation. 

 A dedicated wire diagnostics multi-meter, the DCM has been designed with operator safety in mind. This provides the operator with essential functionality, whilst utilising a simple and intuitive user interface.

 Utilising a 4-wire configuration, RDT dramatically reduces the complexity of the resistance substitution process. The RDT has 3 substitution modes from its compact form factor of  only 70mm x 50 mm x 30mm, and weighs just 149g.

The CSR is used to help  identify current being shared though multi wires.  The CSR provides a 10Ω inline resistance, matching the internal impedance of the Trimax DCM.

Resistor sticks are also available.

The  VDT measures and duplicates DC voltages on signal lines where a high level of accuracy, continuity and reliablity is required.

VDT is the the only COTS solution available to counter emerging voltage-based threats.

Used for identification, analysis and replication of ultrasonic signals, the USAT can measure and replicate a detected signal with tandem probes, allowing a staged approach.

USAT is supplied with 1x Rx and 2x Tx probes.

 DBAT can be introduced into a system to analyse an ID or ID+ digital signal. DBAT can continue to replicate the signal, removing any detected biscuits from the system. On screen instructions guide the user through deployment.

  A portable desktop training aid that allows end users to perform render-safe procedures against up to 8 individual zones.

End users can practice taking voltage and current measurements against the supplied target cables.

The unit will automatically detect the configuration of the target wires and monitor each zone. The VIT unit will indicate a change in those states via audible and visual outputs. 

 These diagnostic boxes allow operators to practice their electronic diagnostic render-safe procedures using either Trimax tooling or their own current capabilities. 

The boxes can be used with an ethernet cable or custom cables, and are reconfigurable to prevent users from learning a standardised setup. 

Variants comprise: Passive switches, 12V commercial PIR, a Voltage sensor and a small 12V PIR and reed switch

Detect. Demodulate. Hunt.

This next generation handheld signal finding device is a 'best-in-class' frequency analyzer designed to evolve with emergent threats. 

Built by TSCM operators, for TSCM operators, the Dark Compass runs real-time sweeps in the 70Mhz to 6Ghz spectrum. 

With over-the-air updates, you'll always stay one step ahead of the threat.